Makita AN911H specifications Trigger ass’y

Repair

[3]ASSEMBLING/ DISASSEMBLING [3]-4. Trigger valve, Front cushion (cont.)

ASSEMBLING

Refer to previous page and take the disassembling step in reverse. Note: Trigger valve case and Trigger guide have to be firmly inserted

into places until the click sounds can be heard.

Trigger base section has to be assembled so that Lever can be put into the center groove of Change rod.

Do not fail two different length Pins to set in place as illustrated in Fig. 22. After setting 1R268 instead of Spring pins ø3-20/ ø3-32 temporarily, push out 1R268 by setting Spring pins ø3-20/ ø3-32 in place. (Fig. 23)

P 7/ 10

Fig. 21

Center groove
of Change rod	Lever

Fig. 22

Spring pin ø3-20
	Spring pin
(For securing Trigger ass’y)	ø3-32 (3pcs.)

Fig. 23

1R268

Spring pin

ø3-20/ ø3-32

step of 1R268 for

receiving ø3mm Spring pin

[3]-5. Trigger ass’y

DISASSEMBLING

Trigger ass’y can be removed by pushing out two Spring pins ø3-32. (Fig. 22)

Refer to Fig. 24 for the components as all-in-one package for repair purpose when disassembling Trigger ass’y. Note: Trigger ass’y does not include Change rod.

Fig. 24

	Trigger ass’y
	Lever	Trip lever
	Torsion spring 4	Torsion spring 4
Torsion spring 5	(Part No. 233503-1)	(Part No. 231699-2)
	Steel ball 4	Trigger
Stopper plate	Compression	Spring pin 2-12
	spring 2
Torsion spring 6
	Lever
	(Change rod)	Pin 3
	Trigger base
	Spring cover