Repair
[3]ASSEMBLING/ DISASSEMBLING
[3]-7. Driver guide, Piston for nail loading
REPLACING
(1)Remove Driver guide in accordance with the clause of
(2)Remove two M5x35 Hex socket head bolts for Cylinder.
Note: Be careful that their bolts and Cylinder pop out by reaction force of Compression spring 6 and Compression spring 9.
Refer to Fig. 29 and replace the damaged parts.
Note: 
When setting Cylinder in place, tighten two M5x35 Hex socket head bolts alternately to provide same torques. Do not lean Piston.
Urethane ring 4 is used on Torsion spring 4 with Feeding claw. Do not mistake Urethane ring 3 for the position of Urethane ring 4.
Fig. 30
P 9/ 10
Fig. 29
Trigger base
Trigger
Pin 3
Hook of Lever
Torsion spring 4
Contact arm cover
Push rivet
Flat washer 4
Cover
Flat washer 4
Push rivet
Contact arm 
Nose adapter
|
|
| M5x35 Hex socket |
|
|
| head bolt |
|
|
| Flat washer 5 |
Urethane ring 4 |
|
| Cylinder |
| Torsion spring 9 | O ring 22.4 | |
|
|
| Compression spring 9 |
Feeding |
|
| Compression spring 6 |
|
|
| |
claw |
| Piston | Rubber ring 13 |
|
|
| |
| O ring 9 | O ring 14 | |
|
| ||
| Pin 4.5 |
| |
| Urethane | Door |
|
|
| Lock lever | |
| ring 3 |
| |
|
|
| |
Urethane |
| Compression spring 5 | |
ring 3 |
| Pin 2.5 | Nail holder |
|
| ||
|
|
| Compression spring 4 |
Pin 4 |
|
|
|
| Pin 2.5 |
|
|
| Check claw |
| M4x14 Hex socket head bolt |
Compression spring 5 | Flat washer 4 | ||
|
| Door cover |
|
|
|
| M4x8 Hex socket head bolt |