Load nails into the magazine so that the nail points will be set into the groove at the bottom of the maga- zine. Move the nails into the ejection slot as far as they will go.
CAUTION : | \ |
Always load the same type and size of nail into the | |
magazine. If you load the tool with different types |
|
and/or sizes at the same time, a malfunction may | 3river guide / |
result. | Groove |
To close the slide door, slide it toward the driver guide until the slide door is locked by the leaf spring.
Adjusting depth of nailing
CAUTION :
Always lock the trigger and disconnect the hose before adjusting the depth of nailing.
The depth of nailing can be adjusted by moving the driver guide up or down. When moving the driver guide to the higher position, you can obtain a deeper depth of nailing; when moving it to a lower position, you can obtain the shallower depth of nailing. To adjust the depth of nailing, proceed as follows:
1 . Remove hex wrench 3 from the hook.
2. Turn the adjusting bolt with hex wrench 3 until the | Hex wrench 3 | I |
adjusting bolt contacts the projection of the center | ||
plate. |
|
|
.
I | Projection of center plate |
I
11