TOOL INSTALLATION INSTRUCTIONS AND USE Lubrication
To insure maximum performance, install an air set (oiler, regulator, air filter) as close as possible to the tool. Adjust the oiler so that one drop of oil will be provided for every 50 nails.
When an air set is not used, oil the tool with pneumatic tool oil by placing 2 (two) or 3 (three) drops into the air fitting. This should be done before and after use. For proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced.
| I | E |
Loading nailer |
| |
|
| |
CAUTION : |
|
|
Always lock the trigger by turning the lock knob (lock |
|
|
pin) 90" and disconnect the hose before loading the |
|
|
nailer. |
| Lock knob (Lock pin) |
|
|
To open the slide door, pull the door knob toward you while pushing up the leaf spring.
. _ .. | . . . . |
Slide door
10