| Connecting air hose |
| Lock the trigger. Slip the air socket of the air hose |
r | onto the air fitting on the nailer. Be sure that the air |
socket locks firmly into position when installed onto | |
the air fitting. A hose coupling must be installed on or | |
near the tool in such a way that the pressure reservoir | |
| will discharge at the time the air supply coupling is dis- |
| connected. |
I
I
.i
II
Operation
Release the trigger by turning the lock knob. Place the driver guide agianst the workpiece and pull the trigger. Nails will be driven into the workpiece. When nails are depleted, the trigger cannot be pulled because a mechanism actuates. Load nails into the magazine, and the trigger can now be pulled.
CAUTION :
.The mechanism cannot actuate when the slide door is open. So always lock the trigger by turn- ing the lock knob to prevent accidental firing when the slide door is open.
Operating the tool without nails shortens the life of the tool and should be avoided.
Air exhaust
Air exhaust direction can be changed easily by rotating the exhaust cover. Change it when necessary.
xhaust cover
Jammed nailer
When the nailer becomes jammed, proceed as follows: 1 . First, lock the trigger and disconnect the hose.
2.Remove the three screws which secure the driver guide. Remove the driver guide.
3.Remove the jammed nail from the ejection slot.
To reassemble the tool, perform the above operations in reverse sequence.
13