Makita AN901 instruction manual Nose adapter, Loading nailer

Page 12

Nose adapter

CAUTION:

Always lock the trigger and disconnect the hose before installing or removing the nose adapter.

When nailing workpieces with easily-marred surfaces, use I

I

Nose piece storing portion

 

Attach the nose adapter to the contact arm (see right). When not in use, store the nose adapter at the rear of the tool to keep it from being lost.

1Nose adapter

Loading nailer

CAUTION:

Always lock the trigger and disconnect the hose before loading the nailer.

Select nails suitable for your work.

Depress the latch lever and open the door and magazine cap.

Lift and turn the coil support plate to set the correct step. When loading 90 mm (3-1/2”) long nails, use the bottom step. When loading 65 or 75 mm (2-1/2”, 3”) long nails, use the middle step. When loading 45 or 50 or 57 mm (1-3/4”, 2”,2-1/4”) long nails, use the top step. If the tool is operated with the coil support plate set to the wrong step, poor nail feed or malfunction of the tool may result.

1

 

 

LMagazine cap

DoorJ

L-Latc,

lever

7Magazinescale

Coil support plate

12

Image 12
Contents Construction Coil Nailer Safety Instructions Page Kgf/cm2G AIR Triggerlock Page Page ?&1 Page Selecting compressor Selecting air hoseLubrication Nose adapter Loading nailerAdjusting depth of nailing Connecting air hoseOperation Air exhaust Jammed nailerHook Nails Maintenance Maintenance of nailerMaintenance of compressor, air set and air hose Page Memo Makita Limited ONE Year Warranty