Woodstock W1831 owner manual Assembly, Dust Collection

Page 16

Model W1831 (For Machines Mfg. Since 2/12)

Assembly

Place the spindle hex nut, table inserts, sanding drums and sleeves, and spindle washers in the appropriate sized accessory slots beneath the table.

Note: A sanding drum does not need to be installed until after the test run.

Table Inserts

Sanding Drums

and Sleeves

SETUP

Dust Collection

Recommended CFM at Dust Port:

100 CFM

Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must take into account many variables, including the CFM rating of the dust collector, the length of hose between the dust collector and the machine, the amount of branches or Y's, and the amount of other open lines throughout the system. Explaining this calculation is beyond the scope of this manual. If you are unsure of your system, consult an expert or purchase a good dust collection "how-to" book.

DO NOT operate this machine without an adequate dust collection system. This machine creates substan- tial amounts of wood dust while operating. Failure to use a dust collection system can result in short and long-term respiratory illness.

Figure 7. Table inserts, drums, and sleeves

placed on sander base.

112" Dust Port

Figure 8. Dust port location.

-14-

Image 16
Contents OWNERS MANUAL Shop FOX Oscillating Spindle SanderPage Contents Introduction Woodstock Technical SupportModel W1831 Construction Materials Controls and Features Machine identificationFor.Your.Own.Safety SafetyStandard.Machinery.Safety.Instructions STABLE.MACHINE..Unexpected movement during Additional Safety for Sanders Electrical Circuit RequirementsPolarized Plug Extension CordsUnpacking SetupInventory Machine Placement Cleaning Machine SetupBench Mounting Example of a direct mountAssembly Dust CollectionTest Run To test run the machineOperations Disabling SwitchGeneral Sanding Drum/Sleeve Installation SandingAccessories Sander AccessoriesCleaning MaintenanceSchedule Service Changing Motor BrushesTools Required Troubleshooting Problem Possible CauseWiring Diagram 120 VACParts Main BreakdownMain Parts List DescriptionLabel Placement DescriptionModel W1831 For Machines Mfg. Since 2/12 Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools