Woodstock W1831 owner manual Tools Required

Page 23

Model W1831 (For Machines Mfg. Since 2/12)

Tools Required:

Qty

Screwdriver Phillips #2

1

To change motor brushes:

 

1.DISCONNECT SANDER FROM POWER.

2.Turn machine on its side, and remove the screws securing the base plate, then remove the base plate to allow access to the motor.

3.Disconnect the wire attached to the motor brush assembly.

4.Loosen the screws that secure the clamp plate over the brush assemblies (see Figure 16) but do not completely remove the plate.

5.Gently pull the brush assembly straight toward you and then upward to remove it.

6.Install new motor brush assembly.

7.Tighten the clamp plate back in place.

8.Repeat these steps to change the second motor brush assembly.

9.Reconnect the wire to the motor brush.

10.Replace the base plate.

Motor Brushes

Clamp Plates

Figure 16. Motor brush location on motor.

SERVICE

-21-

Image 23
Contents Shop FOX Oscillating Spindle Sander OWNERS MANUALPage Contents Woodstock Technical Support IntroductionModel W1831 Construction Materials Machine identification Controls and FeaturesStandard.Machinery.Safety.Instructions SafetyFor.Your.Own.Safety STABLE.MACHINE..Unexpected movement during Additional Safety for Sanders Circuit Requirements ElectricalExtension Cords Polarized PlugInventory SetupUnpacking Setup Machine Placement Cleaning MachineExample of a direct mount Bench MountingDust Collection AssemblyTo test run the machine Test RunGeneral Disabling SwitchOperations Sanding Sanding Drum/Sleeve InstallationSander Accessories AccessoriesSchedule MaintenanceCleaning Changing Motor Brushes ServiceTools Required Problem Possible Cause Troubleshooting120 VAC Wiring DiagramMain Breakdown PartsDescription Main Parts ListDescription Label PlacementModel W1831 For Machines Mfg. Since 2/12 Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools