Woodstock W1831 owner manual Test Run, To test run the machine

Page 17

Model W1831 (For Machines Mfg. Since 2/12)

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly and is ready to operate.

Note: You do not need to install a drum to perform the test run.

The test run consists of verifying the following: 1) The motor powers up and runs correctly, and 2) the safety disabling mechanism on the switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 22.

If you still cannot remedy a problem, contact our Tech Support at (360) 734-3482 for assistance.

To test run the machine:

1.Make sure you understand the safety instructions at the beginning of the manual, and verify that the machine is setup properly.

2.Ensure all tools and objects used during setup are cleared away from the machine.

3.Connect the machine to the power source.

4.Verify that the machine is operating correctly by turning the machine ON.

When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

5.Turn the machine OFF.

6.Remove the switch disabling key (see Figure 9).

7.Try to start the machine with the paddle switch.

If the machine does not start, the switch disabling feature is working as designed.

If the machine starts, immediately stop the machine. The switch disabling feature is not working correctly. Call Tech Support for help.

-15-

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses to reduce the risk of injury.

Figure 9. Removing switch key from

paddle switch.

SETUP

Image 17
Contents Shop FOX Oscillating Spindle Sander OWNERS MANUALPage Contents Woodstock Technical Support IntroductionModel W1831 Construction Materials Machine identification Controls and FeaturesStandard.Machinery.Safety.Instructions SafetyFor.Your.Own.Safety STABLE.MACHINE..Unexpected movement during Additional Safety for Sanders Circuit Requirements ElectricalExtension Cords Polarized PlugInventory SetupUnpacking Setup Machine Placement Cleaning MachineExample of a direct mount Bench MountingDust Collection AssemblyTo test run the machine Test RunGeneral Disabling SwitchOperations Sanding Sanding Drum/Sleeve InstallationSander Accessories AccessoriesSchedule MaintenanceCleaning Changing Motor Brushes ServiceTools Required Problem Possible Cause Troubleshooting120 VAC Wiring DiagramMain Breakdown PartsDescription Main Parts ListDescription Label PlacementModel W1831 For Machines Mfg. Since 2/12 Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools