
ASSEMBLY
Stand (W1723)
The Model W1723 is equipped with a stand that can be mounted to a mobile base.
USE helpers or power lifting equipment to lift this planer. Otherwise, serious personal injury may occur.
To assemble the stand and mount the planer, do these steps:
1.Insert (2)
2.Rotate the cutterhead so the knife edges are clear, and lower the cutterhead casting so the (2)
3.Layout all stand legs, supports and hardware; and use the
4.Use mechanical lifting equipment or helpers and set the planer on the stand.
5.Secure the planer to the stand at all four corners with the four
Handwheel
The handwheel operates the
To mount the handwheel and crank, do these steps:
1.Install the key in the shaft, and slide the handwheel onto the shaft.
2.Install the 8mm flat washer and tighten the
3.Thread and tighten the handle into the handwheel to keep the crank locked in place.
Figure 3. Suggested lifting fixture.
Figure 4. W1723 stand assembly.
Hex Nut
and
Washer
Figure 5. Installed handwheel and handle.
10