Woodstock W1724, W1723 Extension Rollers, To mount the extension rollers, do these steps

Page 13

Extension Rollers

The extension roller assemblies are identical for both the infeed and the outfeed ends of the table. To help minimize snipe, you may have to adjust the extension rollers periodically so they are approximately 0.030" above the table.

To mount the extension rollers, do these steps:

1.Loosen the setscrews where the table rollers mount to the planer body (on both ends) as shown in Figure 6.

2.Use a wrench to lower the rollers on their eccentric shafts

3.Position the extension roller assemblies on the planer table, and install the M8-1.25 x 20 mounting bolts and washers finger tight.

4.Place a straightedge across the table and the extension rollers as shown in Figure 7.

5.Turn the adjustment setscrews shown in Figure 8, so the extension roller assemblies are flush with the table surface as indicated by the straightedge.

6.Tighten the mounting bolts to secure the extension bar in place. See Figure 8.

The top of the rollers should now be completely even with the top of the table. Double-check to make sure that the rollers did not move during the tightening process.

DO NOT adjust the table rollers you previously retracted into the planer table, because the final set of adjustments will be explained in the ADJUSTMENTS section.

Table

Roller

Setscrew

Eccentric

Figure 6. Table rollers and setscrews.

ASSEMBLY

Figure 7. Extension roller-to-table alignment.

Extension

Bar

Mounting

Bolt

Adjustment

Setscrew

Figure 8. Installed roller extension.

11

Image 13

Contents Models Page Contents Introduction Woodstock Service and SupportAbout Your New Planer Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstSafety Additional Safety Instructions for Planers 220V Operation ElectricalExtension Cords GroundingBox Contents AssemblyOverview Shop Preparation Cleaning PlanerHandwheel Stand W1723To mount the handwheel and crank, do these steps To mount the extension rollers, do these steps Extension RollersTo assemble the knife setting jig, do these steps Knife Setting Jig W1723Spiral Knife Alignment Tool W1724 Planer Overview AdjustmentsTo check the cutterhead-to-table alignment, do these steps Cutterhead AlignmentUnderside of planer table Adjustments Inspecting Knives W1723 Knife Replacement procedureTypical Shop FOX cutterhead Knife Replacement W1723Gib bolt tightening sequence Spiral knife system Knife Replacement W1724Twisting knife and aligning gib Feed Rollers Chip Breaker Chip breaker height adjustment Chip Deflector To adjust the chip deflector, do these stepsAnti-Kickback Pawls Roller Spring Tension To adjust the roller spring tension, do these stepsTable Bed Rollers To adjust the table bed roller height, do these stepsOperations Always Wear Safety Goggles When Operating This machineTest Run Feed RateOperational Tips Only plane a clean workpieceSolutions Troubleshooting Planing ResultsMaintenance General CleaningGear box drain and fill plugs LubricationBelt Tension To adjust the belts, do these stepsSymptom Possible Cause Corrective Action Troubleshooting Machine OperationPlaner Accessories Maintenance Maintenance Description Maintenance Long T Allen Wrench 4MM Maintenance Angle 191⁄2 Long W1723 and W1724 15 Planer Wiring Diagram Warranty Card BOX BELLINGHAM, WA