Woodstock W1723, W1724 instruction manual Adjustments

Page 18

2.Hold the chain away from the sprocket while you turn the sprocket. Make sure, as you adjust each sprocket, that you count the number of teeth that pass a fixed point.

NOTE: As viewed from the underside of planer, moving the sprockets clockwise lowers the cutterhead casting and moving counter-clockwise raises the casting. Each tooth on the corner sprockets equals 0.016" of vertical movement when the sprockets are turned. See Figure 17.

3.After you have the cutterhead casting adjusted to within 0.016" from front-to- back and from side-to-side, tighten the chain so all of the chain slack is removed.

4.Loosen the cutterhead casting mounting screws and use a two-by-four to pry and lift/lower the cutterhead casting until the casting and table are parallel with each other.

NOTE: This adjustment may require some trial and error and two people. One person holds the head casting in position with the two-by-four, and the other tightens the casting mounting screws shown in Figure 15.

5.Adjust each column on both sides until the cutterhead casting is properly set. While adjusting the columns, tighten each screw after each step to ensure accurate results.

If you have already adjusted the knives on the Model W1723, or you have the Model W1724, go to Page 22 and adjust the feed rollers and chip breaker.

ADJUSTMENTS

16

Image 18
Contents Models Page Contents Woodstock Service and Support IntroductionAbout Your New Planer Warranty and Returns SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingSafety Additional Safety Instructions for Planers Extension Cords Electrical220V Operation GroundingAssembly Box ContentsOverview Cleaning Planer Shop PreparationStand W1723 HandwheelTo mount the handwheel and crank, do these steps Extension Rollers To mount the extension rollers, do these stepsKnife Setting Jig W1723 To assemble the knife setting jig, do these stepsSpiral Knife Alignment Tool W1724 Adjustments Planer OverviewCutterhead Alignment To check the cutterhead-to-table alignment, do these stepsUnderside of planer table Adjustments Knife Replacement procedure Inspecting Knives W1723Knife Replacement W1723 Typical Shop FOX cutterheadGib bolt tightening sequence Knife Replacement W1724 Spiral knife systemTwisting knife and aligning gib Feed Rollers Chip Breaker Chip breaker height adjustment To adjust the chip deflector, do these steps Chip DeflectorAnti-Kickback Pawls To adjust the roller spring tension, do these steps Roller Spring TensionTo adjust the table bed roller height, do these steps Table Bed RollersTest Run Always Wear Safety Goggles When Operating This machineOperations Feed RateOnly plane a clean workpiece Operational TipsTroubleshooting Planing Results SolutionsCleaning Maintenance GeneralLubrication Gear box drain and fill plugsTo adjust the belts, do these steps Belt TensionTroubleshooting Machine Operation Symptom Possible Cause Corrective ActionPlaner Accessories Maintenance Maintenance Description Maintenance Long T Allen Wrench 4MM Maintenance Angle 191⁄2 Long W1723 and W1724 15 Planer Wiring Diagram Warranty Card BOX BELLINGHAM, WA