22.Securely connect the wiring harness connector to the receiver connector, and connect the blue and yellow wires to the blue and yellow wires from the receiver (Figure 4).
23.Turn the receiver so that the flat side aligns with the open side of the hanger bracket (Figure 15). Fold and position the wires into the space above the hanger ball and into the outlet box.
24.Feed the wires and connectors around the out- side of the receiver, through the open side of the hanger bracket, and into the outlet box. Slide the receiver up and over the hanger bracket. Remove the backing on the foam adhesive pads and press the receiver against the ceiling.
25.To complete the ceiling fan assembly, skip to the “FINAL ASSEMBLY” section of this Owner’s Manual.
SECTION B
Assembly Instructions for
Installing the CF2500 Ceiling Fan with Any Other Control Method
7.Route the white, blue, and black motor leads through the downrod. Fold the yellow, red, and brown wires into the slot in the motor coupling, slide the downrod down the wires and seat the downrod in the motor coupling (Figure 18).
8.Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 18). The clevis pin must go through the holes in the motor coupling and the holes in the downrod . Push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the hanger ball to make sure the clevis pin is properly installed.
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
(excluding the SW375 Receiver,
SR330 Remote Control or the
SW350 Wall Control)
1.Position the fan motor and housing assembly in the lower foam packing so that the top of the motor is facing you.
2. Separate, untwist and unkink the four motor leads.
3.Obtain the hanger ball/downrod assembly and remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 16). Remove the pin from the downrod , then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 9.
CLEVIS PIN
SETSCREW
CLEVIS PIN
HAIRPIN
CLIP
CLEVIS
PIN
DOWNROD
HAIRPIN
CLIP
MOTOR
COUPLING
DOWNROD
CLEVIS
PIN
MOTOR
COUPLING
HANGER BALL
DOWNROD
Figure 16
SETSCREW
4.Push the uplight yellow lead assembly connector through the downrod (Figure 17) until it extends about 4”.
5.Cut the yellow lead approximately 3” from the end of the pipe. Strip insulation 1/2” from end of the wires.
6.Using the wire connector supplied, connect the uplight yellow lead assembly to the yellow lead from the fan motor and housing assembly (Figure 18).
4" | UPLIGHT YELLOW | CUT | |
LEAD ASSEMBLY | |||
| HERE | ||
|
| ||
| DOWNROD | 3" |
Figure 17
Figure 18
9.Install the setscrew (supplied in loose parts bag) in the motor coupling and tighten using the 5/32" setscrew wrench (supplied) (Figure 19).
8