Sensor and Module Placement Overview
Above is a typical location where installing a conventional “wired” exit sensor would require cutting and trenching across more than 50 feet of asphalt driveway.
Driveway
RANGE:
12 ft. radius (max)
25 ft. from gate (min)
Open Gate
Outside
Sensor Range
NOTE: Place the transmitter on the same side of the driveway in the line of sight of the receiver to maximize the range.
SENSOR:
2 feet from driveway (max) and 12” deep
Transmitter
100’ Max
Wireless
Gate Opener
Receiver
Sensor Placement
Determining Sensor Location
IMPORTANT: Clear an area 20 feet in all directions of metal tools, toys and automobiles, to prevent magnetic disturbance during testing and installation.
•Determine the optimum location for the VEHICLE SENSOR using the information found above in “Sensor and Transmitter Placement Overview”. Then dig a hole approximately 10 - 12 inches deep and 24 inches long within 2 feet and parallel to the edge of the driveway. Next, dig a trench no more than 15 ft from this hole to the location where you will install the transmitter module. Keep the VEHICLE SENSOR and the cable uncovered at this time.
For Optimum Performance:
•Locate the SENSOR as far as possible away from power transformers, power lines, underground gas line, and telephone lines.
•Locate the SENSOR away from general moving traffic to prevent unwanted activation. Remember that the SENSOR detects MAGNETIC DISTURBANCES caused by a vehicle’s mass and velocity.
•Range distance is approximate and will vary due to outside interference, type of soil, vehicle mass, speed, etc.
•It is recommended that you run the Signal Cable inside PVC conduit to prevent accidental damage.
•Do not run Signal Cable in conduit with other wires such as AC power or other control wires.
•The SIGNAL CABLE CANNOT BE SPLICED. If you need more wire, contact the GTO Sales Department at
2 | W i r e l e s s E x i t S e n s o r |