Transmitter Module Placement, Install the Vehicle Sensor

Transmitter Module Placement

Determining Transmitter Module Location

•Choose a location for the transmitter module that is far enough from the driveway edge that vehicles are unlikely to hit it. Fifteen feet of wire is included to allow the transmitter to be 12 to 15 feet from the driveway. To test the chosen location to be sure it is free from obstructions or other interference, you can use your remote control transmitter at the same height as the transmitter module to activate the gate.

Receiver

Driveway

10 -12 inch deep pit

100 ft

Maximum

•NOTE: For GTO Receiver #AQ201-NB (Grey in Color) R4500 Wireless Wand is “plug and play” and will work. For GTO Receiver #A2Q201 (Black) and all other model receivers, enclosed RB709U-NB is required.

•After laying the vehicle sensor in the hole adjacent to the driveway. Run the signal cable to the transmitter module in the narrow trench.

Do not fill the hole or trench until satisfactory operation is verified.

Vehicle Sensor

15 ft maximum

Transmitter

Module

Install the Vehicle Sensor

DO NOT fill the hole until final testing is complete.

•Dig a small pit about 10 - 12 inches deep close to the edge of your driveway. The hole should allow you to lay the Vehicle Sensor flat in the bottom with the length of the Vehicle Sensor parallel to the direction of the driveway.

10-12 inch

deep pit

Placed 2 ft maximum			Vehicle Sensor				Vehicle Sensor should
from edge of driveway							lay parallel to driveway


D	R	I	V	E	W	A	Y

W i r e l e s s E x i t S e n s o r