SPECIFIC SAFETY RULES
NEVER perform any operation “freehand” which means using only your hands to support or guide the workpiece. Always use either the rip fence or miter fence to position and guide the work.
NEVER stand or have any part of your body in line with the path of the saw blade.
NEVER reach behind, over, or within three inches of the blade or cutter with either hand for any reason.
MOVE THE RIP FENCE out of the way when cross cut- ting.
NEVER use rip fence as cutoff gauge when cross cutting.
NEVER attempt to free a stalled saw blade without first turning the saw OFF and disconnecting the saw from the power source.
PROVIDE ADEQUATE SUPPORT to the rear and sides of the saw table for wide or long work pieces.
AVOID KICKBACKS (work thrown back toward you) by:
a)Keeping blade sharp.
b)Keeping rip fence parallel to the saw blade.
c)Keeping spreader,
d)Not releasing the work before it is pushed all the way past the saw blade using a push stick.
e)Not ripping work that is twisted or warped or does not have a straight edge to guide along the fence.
IF THE POWER SUPPLY CORD IS DAMAGED, it must be replaced only by the manufacturer or by an authorized service center to avoid risk.
AVOID AWKWARD OPERATIONS AND HAND POSITIONS where a sudden slip could cause your hand to move into the cutting tool.
Use only recommended accessories listed in this manual or addendums. Use of accessories that are not listed may cause the risk of personal injury. Instruc- tions for safe use of accessories are included with the accessory.
make sure the work area has ample lighting to see the work and that no obstructions will interfere with safe operation BEFORE performing any work using the table saw.
ALWAYS TURN OFF SAW before disconnecting it, to avoid accidental starting when reconnecting to power supply.
ONLY USE BLADES within the thickness range stamped on the spreader/riving knife.
THIS TOOL should have the following markings:
a)Wear eye protection.
b)Use saw blade guard and spreader/riving knife for every operation for which it can be used, including all through sawing.
c)Keep hands out of the line of saw blade.
d)Use a push stick when required.
e)Pay particular attention to instructions on reducing risk of kickback.
f)Do not perform any operation freehand.
g)Never reach around or over the saw blade.
SAVE THESE INSTRUCTIONS. Refer to them frequently and use to instruct other users. If you loan someone this tool, loan them these instructions too.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemi- cals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
5