ASSEMBLY
WARNING:
Do not connect the tool to a power supply until all assembly is complete. Failure to comply could result in accidental starting and possible serious injury.
WARNING:
ATTACHING BLADE
See Figures 2 and 2a.
Unplug the saw.
CAUTION:
To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging spindle lock.
Depress the spindle lock button.
Remove the blade screw by turning it clockwise with the wrench, while keeping the lock button depressed.
Remove the spring washer and outer flange washer.
Wipe a drop of oil onto the inner flange bushing and outer flange washer where they contact the blade.
WARNING:
If inner flange bushing has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly.
Retract the lower guard into the upper guard, making sure the lower guard spring works properly, allowing the guard to move freely.
Check to see that the saw teeth and arrow on the saw blade and the arrow on the lower guard are pointing in the same direction.
NOTE: The saw teeth point upward at the front of the saw as shown.
SPINDLE
OUTER
FLANGE
WASHER
INNER FLANGE |
|
|
|
BUSHING | BLADE | SPRING | BLADE |
|
| SCREW | |
|
| WASHER | |
|
|
| Fig. 2 |
OUTER FLANGE |
|
|
|
WASHER |
|
|
|
CUPPED SIDE OF | OUTSIDE OF SPRING |
SPRING WASHER | WASHER |
| Fig. 2a |
|
|
Fit the saw blade inside the lower blade guard and onto the spindle.
NOTE: Be sure that the diamond key on the inner flange bushing aligns properly with the blade before tightening the blade screw.
Replace outer flange washer.
Replace spring washer.
Depress the spindle lock and replace the blade screw.
�Tighten the blade screw securely by turning it counter- clockwise with the wrench. Do not over tighten.
NOTE: Never use a blade that is too thick to allow the outer flange washer to engage with the flat on the spindle.
12