ASSEMBLY
Fit saw blade inside lower blade guard and onto spindle. The blade teeth point downward at the front of saw as shown in figure 12.
Replace outer blade washer. The double "D" flats on the blade washers align with the flats on the spindle.
Depress spindle lock button and replace blade bolt.
Note: The blade bolt has left hand threads. Turn blade bolt counterclockwise to tighten.
CAUTION:
Always install the blade with the blade teeth and the arrow printed on the side of the blade pointing down at the front of the saw. The direction of blade rotation is also stamped with an arrow on the upper blade guard.
Tighten blade bolt securely.
Replace the lower blade guard and blade bolt cover.
Replace screw B and tighten securely.
WARNING:
Make sure the spindle lock button is not engaged before reconnecting saw into power source. Never engage spindle lock button when blade is rotating.
Your compound miter saw has been adjusted at the factory for making very accurate cuts. However, some of the components might have been jarred out of alignment during shipping. Also, over a period of time, readjustment will probably become necessary due to wear. After unpacking your saw, check the following adjustments before you begin using saw. Make any readjustments that are necessary and periodically check the parts alignment to make sure that your saw is cutting accurately.
WARNING:
Your saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades, or when not in use. Disconnecting your saw will prevent accidental starting that could cause serious injury.
ADJUSTMENTS
Note: Many of the illustrations in this manual show only portions of your compound miter saw. This is intentional so that we can clearly show points being made in the illustrations. Never operate your saw without all guards securely in place and in good operating condition.
SQUARING THE SAW BLADE TO THE FENCE
See Figures 13 - 17
Remove the sliding miter fence by loosening the set screw and the sliding miter fence knob.
Lay a framing square flat on the miter table. Place one leg of the square against the fence. Slide the other leg of the square against the flat part of saw blade.
Note: Make sure that the square contacts the flat part of the saw blade, not the blade teeth.
Unplug your saw.
WARNING:
Failure to unplug your saw could result in acciden- tal starting causing possible serious personal in- jury.
Remove the screws holding the throat plate in place. |
Remove the throat plate. |
Pull the saw arm all the way down and engage the lock |
pin to hold the saw arm in transport position. |
Loosen the miter lock handle approximately |
turn. |
SOCKET HEAD
SCREW(S)
FENCE
50
45
40
SOCKET HEAD
SCREW(S)
50
45
40
Depress the miter lock plate and rotate the miter table |
until the pointer on the control arm is positioned at 0°. |
Release the miter lock plate and securely tighten the |
miter lock handle. |
35 |
|
|
|
|
|
|
|
|
| .625 | 35 |
31. |
|
|
|
|
|
|
|
|
|
| |
625 | 30 |
|
|
|
|
|
|
|
| 31 |
|
| 22.5 |
|
|
|
|
|
|
| 30 |
| |
| 25 | 20 |
|
|
|
|
| 22.5 | 25 |
| |
|
|
|
|
|
|
|
| 20 |
|
| |
|
|
| 15 | 5 | 1 | 1 2 | 1 2 | 1 | 15 |
|
|
|
|
|
|
|
| 0 |
| 5 |
|
|
Fig. 13
15