ASSEMBLY
TABLE EXTENSION
See Figure 11.
The table extension can be used on the left side of your miter saw. To assemble and install the table extension:
Insert socket head screw and washer into the two holes in the side of the miter saw base.
Tighten securely.
TO INSTALL BLADE
See Figure 12.
WARNING:
A 10 in. (254 mm) blade is the maximum blade capacity of your saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade bolt from securing the blade on the spindle. Either of these situations could re- sult in a serious accident and can cause serious personal injury.
Unplug your saw.
WARNING:
Failure to unplug your saw could result in acciden- tal starting causing possible serious personal in- jury.
Raise saw arm.
Rotate lower blade guard up and remove screw B. Ro- tate blade bolt cover up and back to expose the blade bolt.
Depress the spindle lock button and rotate the blade bolt until the spindle locks.
Using the wrench provided, loosen and remove the blade bolt. See Figure 12.
Note: The blade bolt has left hand threads. Turn blade bolt clockwise to loosen.
Remove outer blade washer. Do not remove inner blade washer.
Wipe a drop of oil onto inner blade washer and outer blade washer where they contact the blade.
WARNING:
If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly.
TABLE EXTENSION
SOCKET HEAD
SCREW WASHER
Fig. 11
SCREW B
BLADE BOLT
COVER
LOWER
BLADE GUARD
BLADE
FLAT (S)
TO 
ON SPINDLE LOOSEN
TO
TIGHTEN
INNER BLADE
BLADE BOLTWASHER WITH DOUBLE "D" FLATS
OUTER BLADE WASHER
WITH DOUBLE "D" FLATS
Fig. 12
14