RIDGID AC9944 manual Opening the Workstand, Setup, To remove saw from workstand, See Figures 15

�To remove saw from workstand:

Push locking lever release buttons and raise the locking levers to unlock the saw mounting brackets assembly.

�� Grasp the handles on either side of the assembly and lift away from the rear edge of the table to disengage.

�With the assembly tilted slightly toward you, lift the front part of the assembly to disengage from the front edge of the table.

CAUTION:

Do not mount miter saw to workstand before ensuring workstand can be opened and locked securely. Failure to do so may result in possible injury and damage to the tool.

OPENING THE WORKSTAND

See Figures 15 - 16.

SETUP:

NOTE: If saw is mounted, ensure that saw is in folding transportation position. See figure 17.

From the upright position, pull the lock knob and lift legs up until the spring pin locks into place.

WARNING:

To reduce the risk of injury, make sure leg set is secured in the notch by the lock knob. Failure to latch may cause workstand to fall in use.

Slowly lower workstand until the legs rest on the ground.

Stand at wheel end of workstand and grasp the lift assist handle. Push down on lock mechanism release lever and lift workstand into raised position.

NOTE: The workstand is heavy. Get help when needed.

WARNING:

To avoid serious personal injury when lifting, bend your knees so you can lift with your legs, not your back.

CAUTION:

Do not lift by any part of the miter saw that is attached to the workstand. Failure to heed this warning may result in possible injury and damage the tool.

Step on leg support while lifting table up by lift assist handle. The wheels should move further under workstand until unit is locked into place.

Ensure workstand is locked into position before use.

LOCKING LEVER

RELEASE BUTTON

PUSH IN AND

LIFT TO UNLOCK

LIFT TO

RELEASE LEVER

LOCKING LEVER

AVERTISSEMENT

ADVERTENCIA

Miter