•Fixture must be connected to a 120 Volt, 60 Hz power source. Any other connection voids the warranty.
•Keep away from flammable objects.
•The electrical system, and the method of electrically connecting the fixture to it, must be in accordance with the National Electric Code and local building codes.
•Disassembly of the fixture will void the warranty.
•Use only a 65 watt, PL type fluorescent bulb. Use of any other bulb will damage the fixture and void the warranty.
•Fixture must be connected to a 120 Volt, 60 Hz power source. Any other connection voids the warranty.
•Keep away from flammable objects.
•The electrical system, and the method of electrically connecting the fixture to it, must be in accordance with the National Electric Code and local building codes.
•Disassembly of the fixture will void the warranty.
•Use only a 65 watt, PL type fluorescent bulb. Use of any other bulb will damage the fixture and void the warranty.
WARNING: Deviation from the assembly instructions may result in a risk of fire or electric shock.
SAVE THESE INSTRUCTIONS |
| |
Important: Read Before Using! |
| |
Remove cardboard insert that is protecting bulb before use. |
| |
Step 1: Loosen the knob (turn | (C) | |
on the back and top of the fixture (C). | ||
| ||
Step 2: The doorframe and lens assembly will swing down |
| |
allowing access to the bulb. Remove the card- |
| |
board insert. |
| |
Step 3: Replace the door frame and lens assembly and |
| |
secure it by tightening the knob that was loosened |
| |
in Step 1. |
|
Assembling the fixture
Step 1: Slide the upper handle with foam grip into the tube on the
Step 2: Align the threaded screw holes in the handle with the two holes in the tube and secure with the two screws provided.
Step 3: Slide the end of the “S”stand, with the screw hole in it, into the remaining open end of the tube on the
Step 4: Align the threaded screw hole in the stand with the slotted hole in the tube and secure with the knob provided. NOTE: First, slip the plastic spacer over the screw that extends from the knob, making sure that the flat side of the spacer rests against the knob itself. The curved side of the spacer will rest against the curvature of the stand as the knob is tightened down.
Installing the bulb
Step 1: Loosen the knob (turn
Step 2 The doorframe and lens assembly will swing down allowing access to the bulb. Remove the new fluorescent bulb from its package.
Step 3: Push one of the plastic bulb retainer clips open and carefully insert the bulb under this retainer clip. Repeat the process on the opposite side, then push the bulb into the bulb socket. (D) NOTE: Be careful not to damage the bulb.
31