Sears 113.244530 owner manual ON-OFF Knoi, Tended Until IT has Come to a Complete Stop

Page 15

- ON-OFF KNOI_

a. To turn machine "ON", place fingers on Speed Control/On-Off Knob and pull out.

NOTE: The motor will gradually come up to speed after machine is turned "ON", this is a normal condi- tion.

PULL

b. To turn machine "OFF", push in Speed Control/On- Off Knob. NEVER LEAVE THE MACHINE UNAT-

TENDED UNTIL IT HAS COME TO A COMPLETE STOP.

The variable speed control may be adjusted to the approximate speeds identified on the control panel. Suggested speeds are identified under "Choice of Blade and Speed". Turn the control knob clockwise

(_) to'increase strokes per minute and counter- clockwise (-*-------) to reduce the strokes per minute.

NOTE: To protect the motor the band saw will auto- matically shut off if the work piece is fed into the blade too aggressively or if the blade binds. To restart the band saw; turn machine off, then back on again.

ROTATE

c. To lock knob in "OFF" position, install a padlock

through the post above the knob as illustrated, and lock the padlock, (Padlock is not supplied with the

saw.)

WARNING: For your own safety, always push the on-off knob "OFF" when machine is not in use.

Also, in the event of a power failure (all of your lights go out), push knob "OFF". "LOCKOUT" your knob with a padlock as shown. This will prevent the machine from starting up again when the power comes back on.

15

Image 15

Contents Variable Speed 10-1NCH Band SAW 9ARSWhen Installing or Moving the SAW Safety Instructions for Band SawFull ONE Year Warranty on Craftsman Band SAW Before Using the SAWInspect your workpiece Plan your workFPM Lock the switch Unplug the sawGlossary of terms Before Leaving the SAWFeet Motor specifications and electrical requirementsConnecting to Power Supply Outlet Fire hazard and may also create a shock hazardUnpacking and checking contents Clamping Bandsaw to Workbench AssemblyTable of Loose Parts QTY Mounting Band SAW to WorkbenchTonn,on I J Installing the TableInstalling blade Installing the BladeLock and unplug before making any adjust Ments Tensioning the BladeWith one hand on the knob and the other on Adjusting the Blade Guides and BACK-UP Bearing Padlock, and unplug before making any adjust- mentsTracking the Blade Open. Thrown blades can cause injury Final Table AssemblyAligning the Table Square To the Blade Cover lInstalling the Hose Clip Upper slide lock knob... The upper blade guide Getting to know your band sawTended Until IT has Come to a Complete Stop ON-OFF KnoiMaterial Speed Blade Basic Saw OperationsChoice of Blade and Speed Blade Type and Approximate Speed for CuttingEnough to cause a severe injury Whenever SAW is RunningGeneral MaintenanceBasic band saw operation TiresSears recommends the following accessories MaintenanceProbable Cause TroubleshootingWiring diagram TroubleAlways order by Part Number- Not by Key Number Repair partsLO €4 TO IJU Partnumber Partdescription Model Number Name of Item Variable SpeedInch Band Saw