Sears 113.244530 owner manual Tonn,on I J, Installing the Table

Page 8

assembly

An alternate method of mounting is to fasten band saw to a mounting board. The board should be of suf- ficient size to avoid tipping of saw while in use. Any good grade of plywood or chipboard with a 3/4" mini- mum thickness is recommended. (Thinner chipboard can break.) Once the saw is mounted, securely clamp the board to the workbench using "C" clamps.

24" MIN.

±

18" MIN.

5"

WARNING: Supporting surface where band saw is mounted should be examined carefully after

mounting to insure that no movement during use can result. If any tipping or walking is noted, secure workbench or supporting

surface before operating band saw.

INSTALLING THE TABLE

1.Loosen the upper slide lock knob and position the upper guide assembly all of the way up. Tighten lock knob.

2.Open the front cover of the saw by pulling forward on the finger hold located on the left side of the band saw.

3.Locate the square hole behind the lower right wheel and insert a 1/4-28 x 1" long carriage bolt through this hole from inside the saw.

4.Position the table-trunnion assembly on the back side of the saw so the 1/4-28 x 1" bolt extends

through the curved slot in the trunnion. The trun-

nion should engage the curved mounting rib on the back side of the saw.

5.Install the 1" outside diameter washer and table

lock knob to the end of the bolt and tighten by hand.

Upper Slide

Lock Knob

Upper

Guide

Assembly

Finger

Hold

Table

=L.J

._ Assembly

M

Tonn,on I J

Trunnion Slots

Table Lock

Knob

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents 9ARS Variable Speed 10-1NCH Band SAWSafety Instructions for Band Saw Full ONE Year Warranty on Craftsman Band SAWBefore Using the SAW When Installing or Moving the SAWPlan your work Inspect your workpieceLock the switch Unplug the saw Glossary of termsBefore Leaving the SAW FPMMotor specifications and electrical requirements Connecting to Power Supply OutletFire hazard and may also create a shock hazard FeetUnpacking and checking contents Assembly Table of Loose Parts QTYMounting Band SAW to Workbench Clamping Bandsaw to WorkbenchInstalling the Table Tonn,on I JInstalling the Blade Installing bladeWith one hand on the knob and the other on Lock and unplug before making any adjust MentsTensioning the Blade Tracking the Blade Adjusting the Blade Guides and BACK-UP BearingPadlock, and unplug before making any adjust- ments Final Table Assembly Aligning the Table Square To the BladeCover l Open. Thrown blades can cause injuryInstalling the Hose Clip Getting to know your band saw Upper slide lock knob... The upper blade guideON-OFF Knoi Tended Until IT has Come to a Complete StopBasic Saw Operations Choice of Blade and SpeedBlade Type and Approximate Speed for Cutting Material Speed BladeWhenever SAW is Running Enough to cause a severe injuryMaintenance Basic band saw operationTires GeneralMaintenance Sears recommends the following accessoriesTroubleshooting Wiring diagramTrouble Probable CauseRepair parts Always order by Part Number- Not by Key NumberLO €4 TO IJU Inch Band Saw Partnumber Partdescription Model Number Name of ItemVariable Speed
Top Page Image Contents