Assembly ......................................................................
Removing or Installing the Blade
WARNING: To avoid injury from a thrown work- piece or thrown pieces of blade, do not use a blade larger or smaller than 10" diameter.
WARNING: To avoid injury from unexpected starting, unplug the saw whenever you are removing or installing the blade.
1.Unplug the saw from the outlet
2Loosen the cover plate stop screw with phillips end of the combination wrench, supplied.
3Lift the lower guard up and tilt the lower guard assembly back so the arbor screw is exposed.
4a. For Model 113 235220 & 113 235240 only, find the arbor lock between the upper guard and the miter saw handle press the arbor lock and hold it in firmly while turning the arbor screw The arbor lock will engage within one revolution
4b For either saw model you may lower the blade down on to a scrap piece of wood positioned against the fence This will serve as an alternate locking means
5.Place the 1/4" allen end of combination wrench
supplied into the arbor screw. Remove the arbor screw, outer blade collar, and the blade
NOTE: Pay attention to pieces removed, noting their
position and direction they face (see illustration)Wipe the blade collars clean of any sawdust before installing a new blade
6.Install the new 10" blade (see recommended
accessory list) Make sure the rotation arrow on the blade matches the clockwise rotation arrow on the
upper guard.
7InstaLl the outer blade collar, and arbor screw Turn the alien wrench counter clockwise to secure the
blade Tighten arbor screw securely,
8.Lower the lower blade guard until the slot in cover plate rests all the way down on the coverptate stop screw. Tighten the screw with phillips end of the combination wrench, supplied.
DANGER: Never use saw without cover plate securely in place. It keeps the arbor screw from falling out if it accidentally loosens, and pre- vents the spinning blade from coming off the machine.
9 Be sure the arbor lock is released so the blade
turns freely
NOTE: On Model 113235220 & 113235240, the arbor lock can be damaged by improper use
WARNING: Make sure the collars are clean and properly arranged. After installing a new blade, make sure the blade clears the table slot at the 0 ° and 45 ° bevel positions. Lower the blade into the lower table and check for any contact with the base or turn table structure.
COVER PLATE
ARBORCOVER PLATE
SCREWSTOP SCREW
MITER SAW
HANDLE
ARBOR
LOCK
LEFTHANDTHREAD
\
ARBOR
SCREW
UPPER
BLADE
GUARD
BLADE "COLLARS
BLADE COLLARS
BLADE
:ESSES
BLADE