4Disconnect the FlexBay USB cable and the power cable from the back of the Media Card Reader and from the internal USB connector on the system board (see "System Board Components" on page 102).
5Remove the two screws securing the Media Card Reader.
6Slide the Media Card Reader out through the front of the computer.
7If you are not reinstalling the Media Card Reader, replace the drive panel insert (see "Replacing the Drive Panel Insert" on page 132).
8Replace the bezel (see "Replacing the Bezel" on page 119).
9Replace the computer cover (see "Replacing the Computer Cover" on page 164.
10Connect your computer and devices to electrical outlets, and then turn them on.
Installing a Media Card Reader
1Follow the procedures in "Before You Begin" on page 97.
2Remove the computer cover (see "Removing the Computer Cover" on page 99).
3Remove the bezel (see "Removing the Bezel" on page 118).
4If you are installing a new Media Card Reader rather than replacing a Media Card Reader, remove the
5Remove the Media Card Reader from its packaging.
6Gently slide the Media Card Reader into place in the FlexBay slot.
7Align the screw slots in the Media Card Reader with the screw slots in the FlexBay.
8Tighten the two screws to secure the Media Card Reader.
NOTE: Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
9Connect the FlexBay USB cable to the back of the Media Card Reader and to the internal USB connector on the system board (see "System Board Components" on page 102).
134
