Processor
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
Removing the Processor
1Follow the procedures in "Before You Begin" on page 97.
2Remove the computer cover (see "Removing the Computer Cover" on page 99).
3Carefully disconnect and move any cables that are routed over the heat sink assembly.
4Rotate the clamp lever 180 degrees
5Release the clamp grip from the bracket projection on the opposite side.
CAUTION: Despite having a plastic shield, the heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient time to cool before you touch it.
NOTICE: Strong thermal grease bond may exist between the processor and heat sink. Do not use excessive force to separate the heat sink assembly from the processor to avoid damaging the processor.
6Rotate the heat sink assembly upward gently, and remove it from the computer. Lay the heat sink assembly down on its top, with the thermal grease facing upward.
