8If you are not replacing the drive, reinstall the drive panel insert (see "Media Card Reader" on page 133).

9Replace the bezel (see "Replacing the Bezel" on page 119).

10Replace the computer cover (see "Replacing the Computer Cover" on page 164).

11Connect your computer and devices to electrical outlets, and then turn them on.

12Check the system setup for the appropriate diskette Drive Option changes (see "Entering System Setup" on page 172).

Installing a Floppy Drive

1Follow the procedures in "Before You Begin" on page 97.

2Remove the computer cover (see "Removing the Computer Cover" on page 99).

3Remove the bezel (see "Removing the Bezel" on page 118).

4If you are installing a new floppy drive rather than replacing a drive, remove the break-away metal plate from the FlexBay (see "Removing the FlexBay Break-Away Metal Plate" on page 131).

5Gently slide the floppy drive into place in the FlexBay slot.

6Align the screw slots in the floppy drive with the screw slots in the FlexBay slot.

7Tighten the two screws to secure the floppy drive.

8Attach the power and data cables to the floppy drive.

9Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board (see "System Board Components" on page 102) and route the cable through the clip on the shroud.

Removing and Installing Parts

129

Page 129
Image 129
Dell 531 owner manual 129