Removing and Installing Parts 125
8
Connect the data cable to the system board.
9
Check all cables to be certain that they are properly connected and firmly
seated.
10
Replace the computer cover (see "Replacing the Computer Cover" on
page164).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
11
Connect your computer and devices to electrical outlets, and then turn
them on.
12
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
13
Check the system setup for drive configuration changes (see "Entering
System Setup" on page172).
Installing a Second Hard Drive CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, laceration by moving fan blades, or
other unexpected injuries, always unplug your computer from the electrical outlet
before opening the cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set
the drive on a surface, such as a foam pad, that will sufficiently cushion it.
1
Follow the procedures in "Before You Begin" on page 97.
2
Remove the computer cover (see "Removing the Computer Cover" on
page99).
3
Check the documentation for the drive to verify that it is configured for
your computer.
4
Slide the second hard drive into the second hard drive bay.
5
Align the slots in the second hard drive with the guides in the second hard
drive bay.
book.book Page 125 Friday, April 4, 2008 12:10 PM