Removing and Installing Parts 111
8
Right-click the
My Computer
icon and click
Properties
.
9
Click the
General
tab.
10
To verify that the memory is installed correctly, check the amount of
memory (RAM) listed.
Removing Memory
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION: Before removing memory, you must remove the PCI Express x16 card.
See "Cards" on page111.
NOTICE: To prevent static damage to components inside your computer,
discharge static electricity from your body before you touch any of your computer’s
electronic components. You can do so by touching an unpainted metal surface on
the computer chassis.
1
Follow the procedures in "Before You Begin" on page 97.
2
Press out the securing clip at each end of the memory module connector.
3
Grasp the module at the end of the board and lift up.
4
Replace the PCI Express x16 card (see "Cards" on page111).
Cards CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer,
discharge static electricity from your body before you touch any of your computer’s
electronic components. You can do so by touching an unpainted metal surface on
the computer chassis.Your Dell™ computer provides the following slots for PCI and
PCIExpress cards:
• One PCI Express x16 card slot (SLOT1)
• One PCI Express x1 card slot (SLOT2)
• Two PCI card slots (SLOT3, SLOT4)
See "System Board Components" on page102 for card slot location.
book.book Page 111 Friday, April 4, 2008 12:10 PM