Removing and Installing Parts 137
6
Remove the two screws securing the CD or DVD drive.
7
Slide the CD or DVD drive out through the front of the computer.
8
If you are not replacing the drive, replace the drive panel insert (see "Media
Card Reader" on page133).
9
Replace the drive panel insert (see "Replacing the Drive Panel Insert" on
page132).
10
Replace the bezel (see "Replacing the Bezel" on page119).
11
Replace the computer cover (see "Replacing the Computer Cover" on
page164).
12
Connect your computer and devices to electrical outlets, and then turn
them on.
13
Configure the drives in system setup (see "Entering System Setup" on
page172).
Installing a CD or DVD Drive
1
Follow the procedures in "Before You Begin" on page 97.
2
Remove the computer cover (see "Removing the Computer Cover" on
page99).
3
Remove the bezel (see "Removing the Bezel" on page 118).
4
Gently slide the CD or DVD drive into place.
5
Align the screw slots in the CD or DVD drive with the screw slots in the
CD or DVD drive bay.
6
Replace and tighten the two screws securing the CD or DVD drive.
7
Connect the power and data cables to the drive.
8
Connect the data cable to the system board connector on the system
board.
book.book Page 137 Friday, April 4, 2008 12:10 PM