Emerson CF945WB Electrical Requirements, Preset Memory Feature, Installation of Battery, General

Electrical Requirements

Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.

The outlet box must be securely anchored and capa- ble of withstanding a load of at least 50 pounds.

!WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked acceptable for fan support, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture.

!WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

!WARNING

To avoid fire or shock, follow all wiring instructions carefully. Any electrical work not described in these instructions should be done or approved by a licensed electrician.

lights on and off and control the light intensities. The red indicator light will illuminate while any button is pressed, indicating that the battery is good.

The remote control transmitter is powered by a 9-volt alkaline battery (not included). To prevent possible damage if the battery should leak, be sure to remove the battery when the control is not to be used for an extended period of time.

Code switches in the transmitter and receiver may be set in 16 different positions. If your fan and light go on and off without using your control, you may be getting interference from other remote units such as garage door openers, car alarms or security systems. To remedy this situation, simply change the combination code in your transmitter and receiver.

Preset Memory Feature

Your Emerson remote control receiver is equipped with a preset memory feature. If the electrical supply to the receiver is controlled through a wall switch, when the switch is turned off, the control will remember the light intensities and fan speed. When the switch is turned back on, the lights and fan will resume operation as they were prior to the switch being turned off.

Installation of Battery

1.Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 1).

2.Remove the connector from the battery compartment and attach it to the 9-volt alkaline battery (not included).

IMPORTANT

This Owner’s Manual is divided into two sections. The first section, REMOTE CONTROL PROCEDURES, describes how to install the 9-volt alkaline battery (not included) in the remote control transmitter, and how to set the operating frequency of the transmitter and receiver. These instructions must be performed prior to installation of the ceiling fan as described in the second section, CEILING FAN PROCEDURES.

REMOTE CONTROL

PROCEDURES

CODE SWITCH

1 2 3 4

REMOTE CONTROL

RECEIVER

REMOTE CONTROL

TRANSMITTER

BATTERY

CONNECTOR

SWITCH

LEVERS

ON

1 2 3 4

CODE

SWITCH

BATTERY

CODE COVER SWITCH

BATTERY

General

The remote control supplied with your Emerson ceiling fan consists of a hand-held transmitter and a receiver which is mounted in the switch housing. The remote control is designed to separately control your ceiling fan and light intensities. There are four push buttons (HI, MED, LOW, OFF) to set the fan speed and turn the fan off. The REV push button changes the airflow direction of the fan blades. The U/L (uplight) and D/L (downlight) pushbuttons turn the

Figure 1

4