Emerson CF945PW, CF945WB, CF945HTW, CF945AB Setting Operating Frequency of Transmitter Receiver

Setting Operating

Frequency of Transmitter

and Receiver

Your remote control transmitter and receiver have code switches which must be set on one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and 4) on the switches are factory- set in the ON (up) position. Do not use this setting. Change the switch settings as follows:

1.Slide the four switch levers (Figure 1) in the remote control transmitter to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

2.In the receiver, slide the four switch levers in the same positions as set in the transmitter. Make sure the levers on both switches are in the same positions; otherwise the fan will not operate.

3.Position the battery in the transmitter battery compartment and replace the battery cover.

CEILING FAN

PROCEDURES

How to Put Your Ceiling Fan Together

1.Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 2). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 5.

PIN

HANGER

BALL

SETSCREW

DOWNROD

Figure 2

2.Separate, untwist and unkink the two 80” motor leads. Route the motor lead wires through either the 4-1/2” or the 18” downrod. Remove the two upper setscrews from the motor coupling. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 3). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.

Reinstall the upper setscrews in the motor coupling. Check that the lower setscrews are tightened securely (Figure 3).

NOTE: The setscrews must be properly installed as described above, or fan wobble could result.

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed could result in the fan falling.

	DOWNROD
HAIRPIN	CLEVIS PIN
CLIP
	UPPER SETSCREW (2)
LOWER	MOTOR
SETSCREW (2)	COUPLING

Figure 3

3.Make sure the grommet is properly installed in the coupling cover, then slide the coupling cover on the downrod until it rests on the motor housing (Figure 4).

DOWNROD

COUPLING COVER

Figure 4

IMPORTANT

A. If you have installed an 18” or longer downrod and are planning to install the decorative support rods assembly, proceed to “INSTALLATION OF DECORATIVE SUPPORT RODS ASSEMBLY” on page 9. After you have installed the decorative support rods assembly, continue with the following installation procedures.

B.If you have installed the 4-1/2” downrod, continue now with the following procedures.

4.Position the ceiling cover over the downrod. Be sure the cover is oriented correctly, with the large opening at the top (Figure 5).

5