Emerson CF160 owner manual White

BP7358 RUSTICO CF160 9/19/07 11:23 AM Page 10

STANDARD ON-OFF WALL
SWITCH OR OPTIONAL SW115	BLACK
WALL CONTROL

TO	BLACK
	(HOT)
120-
VOLT
SUPPLY
	WHITE
	GROUND

BLACK

WHITE

WHITE

BLACK

TWO-CONDUCTOR

CABLE (WITH

GROUND)

GREEN WIRE (GROUND)

FROM HANGER BALL AND

HANGER BRACKET

Figure 13

BLUE WHITE ORANGE

BLACK

BLUE WHITE

ORANGE

HANGER BALL

3. Push the wires and connectors up into the outlet box while inserting the receiv- er fully into the hanger bracket. Position the antenna wire on top of the receiver.

4. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 12).

5. Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 13).

6. Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 14). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.

CEILING

COVER

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

NOTE: If you wish to operate your ceil- ing fan with the downlight fixture attached, perform steps 7 and 8. Otherwise, skip to step 9.

7. For Operating Your Fan With the Downlight Fixture. Remove the thread- ed plug from the light fitter adapter. Feed the black and white wires of the light fitter assembly through the hole in the adapter and screw the threaded nipple of the light fitter into the adapter hole (Figure 15). Install nut and lock- washer onto threaded nipple inside of adapter and securely tighten.

LOCKWASHER

(2)

KNURLED

KNOB (2)

Figure 14

NUT	LOCKWASHER
	LIGHT
	FITTER
THREADED	ADAPTER
PLUG
THREADED	LIGHT FITTER
STUD (2)
Figure 15	THREADED
	NIPPLE

10 U.L. Model No.: CF160