Emerson CF943 owner manual WAY Installation

2. At all wall box locations remove faceplates and screws from existing switches. Pull switches out from wall boxes and determine which wall box contains the “hot” lead and which wall box contains the “load” wire. Also, identify traveler wires which are common to both wall boxes. Disconnect wires from existing switches only. Do not attempt to disconnect any wires not already connected to existing switches.

BP7335 Palazzo 1/9/07 9:05 AM Page 6

Installation of Wall Control

SINGLE-POLE INSTALLATION (Figure 2)

HOT	BLK	FAN/LIGHT
		WALL CONTROL
	EMERSON	BLACK
		BLACK	LOAD
NEUTRAL			GROUND
REMOTE CONTROL

5. Connect the other black wire of wall control to the “load” (black) wire in wall box. Securely connect wires with wire connector supplied.

6. Screw wall control into wall box and install decorator style faceplate (included). Leave wall control in “OFF” mode until fan installation is completed.

7. Refer to page 7 to complete the ceiling fan installation.

RECEIVER LOCATED

WITHIN THE CEILING

COVER

Figure 2

!WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring.

HI
	LIGHT
MED
LOW
FAN OFF
EMERSON		®
OFF	ON

Figure 3

BLK	T			HOT
	O
	1	2	0V			O		E
			AC		S		C
						UR

T
	O
BLACK	LOAD
			D
			N
			U
	G	R	O
FAN/LIGHT
			WALL
WALL
CONTROL			BOX

All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

3-WAY INSTALLATION

(On fan controlled by two different wall controls) (See Figures 4 and 5.)

1. Disconnect power at circuit breaker or remove fuse.

1. Disconnect power at circuit breaker or remove fuse.

2. Remove faceplate and screws from existing wall switch. Pull switch out from the wall box. Determine the “hot” wire and the “load” wire and disconnect these wires from switch. Do not attempt to disconnect any wires not already connected to existing switch.

3. Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position. 3.

!WARNING

Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position.

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

4. Connect one black wire of wall control to the “hot” wire in the wall box. Securely connect wires with wire connectors supplied (Figure 3).

!WARNING

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

6