BP7335 Palazzo 1/9/07 9:05 AM Page 13
HANGER BRACKET 
THREADED STUDS (2)
Figure 22
OUTLET
BOX
RECEIVER
CEILING
COVER
How to Install
Your Light Kit
CAUTION: To avoid risks of burns or other injury, assure power is off before attempting to install or replace the candelabra base bulbs.
1. Install two 60W (maximum) candelabra base bulbs (not supplied) in the sockets of the light fitter assembly (Figure 24).
2. Unscrew the decorative finial nut and threaded washer from the light fitter assembly threaded stud (Figure 24).
7. Slide the receiver up and over the hanger bracket. Press the receiver against the ceiling, then slide the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 23).
8. Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied) (Figure 23). Tighten the knurled knobs securely
60W (MAX.)
CANDELABRA
BASE BULB (2) LIGHT FITTER SOCKET (2)
THREADED
THREADED 
WASHER STUD
until the ceiling cover fits snugly against the ceiling.
Figure 24
DECORATIVE FINIAL NUT
CEILING
COVER
Figure 23
3. Slide the glass shade onto the threaded stud until the glass rest against the light fitter assembly (Figure 25).
4. Thread the previously removed threaded washer and decorative finial nut onto the threaded stud until finger tight.
LOCKWASHER
(2)
KNURLED
KNOB (2)
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
GLASS | THREADED | |
WASHER | ||
SHADE | ||
|
DECORATIVE
FINIAL NUT
Figure 25
5. Your ceiling fan is now installed and wired to be controlled by your fan/light wall control.
13