Schneider Electric MNA01M001EN manual Part Length in mm inches

Page 43

LXM32

4 Installation

A

1

2

C

3

MNA01M001EN, V1.01, 08.2014

4

B

		PA/+PC/-
	5	PA/+
	5	PC/-
		PC/-

	Part	Length in mm (inches)
A	Cable jacket	130 (5.2)

B	Length of shield connection	60 (2.5)

C	Stripping length	6 (0.25)

	Diameter ring-type cable lug /	For M5 screw
	fork-type cable lug

▶(1) Strip the cable jacket, length A.

▶(2) Slide back the shield braiding. Open the shield braiding and twist it to form a shield connection wire.

▶(3) Shorten the twisted shield connection wire to length B and insu- late the shield braiding with heat shrink tube.

Crimp the crimp contacts to the two stripped conductors. The strip- ping length is C. See chapter "6.1 DC bus accessories", page 55 for information on the crimping tool.

▶(4) Crimp a fork-type cable lug to the shield connection wire. Push the crimp contacts into the connector housing. Polarity: the red wire is PA/+, the black wire is PC/-.

▶(5) Secure the shield with heat shrink tube.

Common DC bus

43

Image 43

Contents LXM32 LXM32 Table of contents Accessories and spare parts Hazard categories Safety InformationIntended use Qualification of personnelBasic information Loss of Control Standards and terminology DC bus voltage measurementLXM32 About the book LXM32 Introduction Permissible device types for common DC bus Firmware version Technical DataDC bus data LXM32 ∙ U45M2 U90M2 D18M2 D30M2 Braking resistorParameter DCbuscompat VW3A760 1Rxx 2Rxx 3Rxx 4Rxx 5Rxx 6Rxx 7Rxx External braking resistors accessoriesCables for the DC bus Engineering Energy balance basics Energy balanceRating DC bus connection Electromagnetic compatibility EMCFuses DC bus connection of single-phase drivesSee .2 DC fuses for fuses for the DC bus Single mains fuse for three-phase drives DC bus connection of three-phase drivesMultiple mains fuses for three-phase drives Supply via the DC bus Supply via the DC bus by a drive LXM32 Rating the braking resistor Braking resistorsPmax Rating information Selecting an external braking resistor Mains reactor L2 L1 PC/- PA/+ Mains filter Mains reactor and external mains filter LXM32 Installation Assembling cables Specifications for drives with mains supplyPart Length in mm inches LXM32∙ D85, C10 Drives with connectors Wiring the DC busNector Properties of the connection termi- nals CN9 Drives with terminalsDC bus connection, example with connector Connecting the DC busVerifying installation LXM32 Commissioning DC bus connection LXM32 to LXM32 Commissioning procedureMONMainsVolt LXM32 Setting the braking resistor parameters DC bus accessories Accessories and spare partsDC fuses External braking resistors Units and conversion tables GlossaryMoment of inertia TemperatureRotation TorqueTerms and Abbreviations LXM32 Table of figures LXM32 EMC IndexLXM32