Schneider Electric MNA01M001EN manual MONMainsVolt

Page 53

LXM32

5 Commissioning

5.1.2Supply via the DC bus

Commissioning steps:

▶Verify proper installation of the drives and the connections for the common DC bus, see chapter "4.3 Verifying installation", page 49.

▶Switch on the controller supply for all devices.

▶LXM32: Set the parameter MON_MainsVolt to "DC-Bus Only" for LXM32.

Parameters	Value
MON_MainsVolt	DC-Bus Only

▶LXM32: Set the parameters for the braking resistors of LXM32 drives, see chapter

"5.2 LXM32: Setting the braking resistor parameters".

▶Commission the drives, see the descriptions in the manuals for the individual products.

MNA01M001EN, V1.01, 08.2014

Common DC bus

53

Image 53

Contents LXM32 LXM32 Table of contents Accessories and spare parts Hazard categories Safety InformationIntended use Qualification of personnelBasic information Loss of Control Standards and terminology DC bus voltage measurementLXM32 About the book LXM32 Introduction Permissible device types for common DC bus Firmware version Technical DataDC bus data LXM32 ∙ U45M2 U90M2 D18M2 D30M2 Braking resistorParameter DCbuscompat VW3A760 1Rxx 2Rxx 3Rxx 4Rxx 5Rxx 6Rxx 7Rxx External braking resistors accessoriesCables for the DC bus Engineering Energy balance basics Energy balanceRating DC bus connection Electromagnetic compatibility EMCFuses DC bus connection of single-phase drivesSee .2 DC fuses for fuses for the DC bus Single mains fuse for three-phase drives DC bus connection of three-phase drivesMultiple mains fuses for three-phase drives Supply via the DC bus Supply via the DC bus by a drive LXM32 Rating the braking resistor Braking resistorsPmax Rating information Selecting an external braking resistor Mains reactor L2 L1 PC/- PA/+ Mains filter Mains reactor and external mains filter LXM32 Installation Assembling cables Specifications for drives with mains supplyPart Length in mm inches LXM32∙ D85, C10 Drives with connectors Wiring the DC busNector Properties of the connection termi- nals CN9 Drives with terminalsDC bus connection, example with connector Connecting the DC busVerifying installation LXM32 Commissioning DC bus connection LXM32 to LXM32 Commissioning procedureMONMainsVolt LXM32 Setting the braking resistor parameters DC fuses Accessories and spare partsDC bus accessories External braking resistors Units and conversion tables GlossaryRotation TemperatureTorque Moment of inertiaTerms and Abbreviations LXM32 Table of figures LXM32 EMC IndexLXM32