Emerson CF130ORB00 Installation Ceiling Cover For Close-to-the-Ceiling, Standard Mounting

BP7404 Tilo 12/16/09 4:06 PM Page 11

Installation of	Installation of
Ceiling Cover For	Ceiling Cover For
Close-to-the-Ceiling	Standard Mounting

NOTE: When installing the ceiling fan using the close-to-the-ceiling method, carefully lift the fan assembly from the hook on the hanger bracket and proceed as follows.

1. After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other inside of the outlet box.

2. Lift the ceiling cover up to the hanger bracket. Engage the slots in the ceiling cover with the loosened screws in the bracket and turn the cover counter- clockwise (Figure 17). Be sure that the lockwashers are between the screw heads and the ceiling cover.

3. Install the remaining two lockwashers and screws (supplied); tighten all four screws securely.

! WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

INSTALL SCREW

AND LOCKWASHER TIGHTEN

CEILINGSCREW

COVER

LOOSEN

THIS

SCREW

FAN HOUSING

Figure 17

1. After connections have been made, turn leads upward and carefully push leads into the outlet box, with the white and green leads on one side of the outlet box and the black and blue leads on the other inside of the outlet box.

! WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

2. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 18).

3. Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 18).

4. Position the ceiling cover ring onto the threaded studs and secure both the ceiling cover and ring in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 18). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.

1-1/4"	CEILING
THREADED
STUD (2)	COVER
	CEILING
	COVER RING
EXTERNAL TOOTH	#8-32 KNURLED
LOCKWASHER (2)
	KNOB (2)

Figure 18

11 UL Model No.: CF130