Installation Hanger Bracket | Emerson CF130ORB00, CF130WW00 specs

BP7404 Tilo 12/16/09 4:06 PM Page 8

Installing the Ceiling

Cover on the

Fan Motor Housing

(For Close-to-the-Ceiling Mounting)

NOTE: The decorative lower cover, coupler cover and hanger ball assembly are not needed for close-to-the-ceiling mounting.

1. Remove and retain three screws from the top of the motor housing (Figure 9).

2. Position the rubber gasket (supplied in parts bag) on the motor housing (small holes in gasket cenered over the screw holes in the housing) Figure 9.

REMOVE AND RETAIN

3 SCREWS (every other one)

RUBBER

GASKET

MOTOR

HOUSING

Figure 9

3. Position the ceiling cover onto the top of the motor housing and reattach the three screws previously removed (Figure 10).

CEILING

COVER

SCREW (3)

RUBBER

GASKET

Installation of

Hanger Bracket

! WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 11).

CEILING

LEAST

FLOOR

Figure 11

! WARNING

The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”.

1. Position the hanger bracket on the outlet box so that the T-slots in the hanger bracket are aligned with the outlet box screws (Figure 12).

NOTE: The four hanger bracket screws and lockwashers are included in the parts bag for this fan. Must be installed for Dual-Mount and NOT used with Downrod (standard) Mount.

Figure 10

	LOOSEN TWO
	SCREWS (SUPPLIED
	WITH OUTLET BOX)	OUTLET
		BOX
	T-SLOT
		SLIDE THE HANGER
		BRACKET ONTO
		THE OUTLET BOX
		SCREWS, THROUGH
		THE T-SLOT
		HANGER
	Figure 12	BRACKET
	Figure 12	UL Model No.: CF130
	8	UL Model No.: CF130