FAN Motor | Emerson CF130BS00, CF130WW00, CF130ORB00 guide

BP7404 Tilo 12/16/09 4:06 PM Page 4

	A. FAN MOTOR	B. HANGER
	ASSEMBLY
		BRACKET

D. CEILING

COVER

F. COUPLER

COVERH. SWITCH HOUSING

G. FAN

BLADES (3)

C. 4.5" DOWNROD ASSEMBLY

E.DECORATIVE LOWER COVER

I. SW46 WALL

CONTROL

J. LOOSE

PARTS BAG

a.Fan motor assembly

b.One hanger bracket

c.One 4.5” downrod assembly

d.One ceiling cover

e.One decorative lower cover

f.One coupler cover

g.Three fan blades

h.One switch housing

i.One SW46 wall control

j.One loose parts bag containing:

1.Three 12 ga. wire connectors

2.Seven M5 x 14mm flange head blade screws

3.Four M5 x 10mm pan head screws

4.Four external tooth lockwashers for hanger bracket assembly

5.One clevis pin

6.One hairpin clip

7.Two threaded stud, #8-32 x 1-1/4”

8.Two external tooth lockwashers

9.Two knurled knobs, #8-32

10.One rubber gasket

11.One balancing kit

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost.

2. Remove the fan motor assembly from the protective plastic bag. Place all carton contents on a protective surface.

IMPORTANT

Your ceiling fan is designed to be installed either in the standard manner, or in the close-to-the- ceiling manner. Using the standard method, the hanger ball/downrod assembly will suspend the fan several inches below the ceiling cover. Using the close-to-the-ceiling method, the ceiling cover installs directly on the fan motor housing, thus mounting the fan 3-1/2 inches closer to the ceiling than the standard method. In no case should the fan blades be lower than seven feet above the floor. Depending on your desired mounting method, proceed to “INSTALLING HANGER BALL/DOWNROD ASSEMBLY” for standard mounting, or to

“INSTALLING CEILING COVER ON FAN MOTOR HOUSING” for close- to-the-ceiling mounting.

4	UL Model No.: CF130

A. FAN MOTOR