BP7404 Tilo 12/16/09 4:06 PM Page 6
7. Position the switch housing assembly on the switch housing plate and align the holes in the switch housing assembly with the holes in the plate. Secure the switch housing assembly by installing the three previously removed M4 x 8mm flat head screws (Figure 3).
!WARNING
PIN
HANGER
BALL
DOWNROD
SETSCREW
To avoid possible fire or shock, do not pinch wires between the switch housing assembly and the bracket switch housing assembly.
SWITCH HOUSING
ASSEMBLY 
REINSTALL M4 x 8mm
FLAT HEAD SCREWS (3)
Figure 3
Figure 4
3. Loosen setscrew in motor coupler if necessary. Separate, untwist and unkink the three 42” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupler. Install the clevis pin and secure with the hairpin clip (Figure 5). The clevis pin must go through the holes in the motor coupler and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.
Installing the Hanger
Ball/ Downrod
Assembly for
Standard Mounting
1. Carefully turn the partially assembled ceiling fan right side up and place the fan securely into the packing sytrofoam in preparation for final assembly.
2. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 4). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 7.
!
WARNING
It is critical that the clevis pin in the motor coupler is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 5) could result in the fan falling.
DOWNROD
HAIRPINPIN |
CLIP |
SETSCREW (2)
CLEVIS PIN
Figure 5
6
MOTOR
COUPLING
MOTOR
COUPLING