Electrical Requirements

BP7404 Tilo 12/16/09 4:06 PM Page 5

Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.

The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.

NOTE: Take care not to scratch fan housing assembly when installing blades.

M5 x 14mm FLANGE HEAD

BLADE SCREWS (2 per blade)

FAN

HOUSING

NOTCHED SWITCH ASSEMBLY

! WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box.

SLIDE FAN BLADE

INTO BLADE

CENTER SLOT

FAN BLADE SLOT

Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need

Figure 1

FAN BLADE

to be replaced. Consult a qualified electrician if in doubt.

If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse or circuit breaker box at this time and remove the existing light fixture.

! WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

4. Complete the remaining two blades installation per the above instructions.

5. Remove the three M4 x 8mm flat head screws from the switch housing adapter plate (Figure 2). Retain the screws for future installation.

6. Engage the connector of the switch housing assembly with the motor connector (Figure 2). The two connectors are keyed and color-coded and must be mated correctly (color-to- color) before they can be engaged. Make sure the connector latch closes properly.