FIGURE 1 | FIGURE 2 |
| 2H |
2B |
|
| 2 I |
| 2F |
2A |
|
2D | 2E |
1A. WATER VALVE: Use to control the water supply to the diamond blade.
1B. WATER INLET: Connect water hose at this garden hose connection.
1C. HANDLE ADJUSTMENT KNOBS: Use to adjust handle height.
1D. ENGINE STOP SWITCH: Stop Switch: Push down to stop engine.
1E. DEPTH CONTROL LOCK: Use to lock the position of the Depth Control Hand Wheel.
1F. DEPTH CONTROL HAND WHEEL: Controls lowering
and raising of the blade into and out of the cut.
2A. BLADE SHAFT NUT: Use to tighten the outer flange against the diamond blade.
2B. OUTER FLANGE: Use to hold the diamond blade in position.
2C. NOT USED
2D. LOCKING PIN: Use to prevent the diamond blade from rotating on the shaft during operation.
2E. DIAMOND BLADE: Use as the cutting tool for concrete and asphalt surfaces.
2F. INNER FLANGE: Inside support used to hold the diamond blade in position.
2G. NOT USED
2H. BLADE GUARD FRONT: The front section of the blade guard.
2I. BLADE SHAFT: Supports the blade flanges and
10