12 Governor Speed
It is critical that the Governor and throttle on all internal combustion engines be adjusted properly. The engine speed is preset at the factory for the proper sawing speed. It is NOT normally necessary to change this setting. It should be periodically verified after the saw is placed into service. To change the Governor setting, refer to the engine manual.
WARNING: Overspeeding the blade can result in blade breakage and/or personal injury to the operator and bystanders!! To assure the proper Governor adjustment, determine the correct blade shaft speed from the following chart. Follow the engine manufacturer’s instruction procedure for Governor and throttle setting.
NO LOAD BLADE SHAFT AND ENGINE R.P.M.s
| BLADE SHAFT | ENGINE |
MODEL | R.P.M. | R.P.M. |
9H 14"/18" | 2610 | 3600 |
2610 | 3600 | |
|
|
|
13 Repairs
We carry out all repairs in the shortest possible time and at the most economical prices. (See back page for our address and phone numbers.)
14 Service Parts
For quick supply of spare parts and to avoid any lost time, it is essential to quote the data on the manufacturer’s plate fixed to the machine and the part number (s) to be replaced with every order.
Write the Model Number & Serial Number here for future reference:
Model Number:____________________
Serial Number:____________________
The instructions for use and spare parts found in this document are for infor-
mation only and are not binding. As part of our product quality
improvement policy, we reserve the right to make any and all technical
modifications without prior notice.
The manufacturer accepts no
responsibility caused by unsuitable
use or modifications
16