Husqvarna 325P5X manual Contents

Page 3

CONTENTS

Contents

 

KEY TO SYMBOLS

 

Symbols

2

CONTENTS

 

Contents

3

Note the following before starting:

3

INTRODUCTION

 

Dear Customer,

4

WHAT IS WHAT?

 

What is what?

5

GENERAL SAFETY PRECAUTIONS

 

Important

6

Personal protective equipment

6

Machines safety equipment

7

ASSEMBLY

 

Fitting the cutting head

14

Fitting the bar and chain

14

Adjusting the harness

14

Filling with oil

14

Assembling and dismantling the two-piece shaft

 

(325P5)

14

Fitting the impact guard (325P5)

15

Assembly of the saw attachment (325P5)

15

FUEL HANDLING

 

Fuel safety

16

Fuel

16

Fuelling

17

STARTING AND STOPPING

 

Check before starting

18

Starting and stopping

18

WORKING TECHNIQUES

 

General working instructions

20

MAINTENANCE

 

Carburettor

23

Muffler

24

Cooling system

25

Spark plug

25

Air filter

25

Maintenance schedule

27

TECHNICAL DATA

 

Technical data

28

EC-declaration of conformity

29

Note the following before starting:

Please read the operator’s manual carefully.

Long-term exposure to noise can result in permanent hearing impairment. So always use approved hearing protection.

WARNING! Under no circumstances may the

!design of the machine be modified without the permission of the manufacturer. Always use genuine accessories. Non-authorized modifications and/or accessories can result in serious personal injury or the death of the operator or others.

WARNING! A pole saw is a dangerous tool if

!used carelessly or incorrectly and can cause serious, even fatal injuries. It is extremely important that you read and understand the contents of this Operator’s Manual.

English – 3

Image 3
Contents 323P4 325P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsVibration damping system Machine′s safety equipmentStop switch Throttle lockMuffler Cutting equipment Specification of bar and saw chainBar With a badly sharpened chain Sharpening your chain and adjusting raker clearanceChain General information on sharpening cutting teethIf the raker clearance is too large General advice on setting raker clearanceSetting the raker clearance Sharpening cutting teethLubricating cutting equipment Tensioning the chainIncrease the risk of accidents Checking wear on cutting equipment ChainWhat to do if lubrication does not work Chain drive sprocketAssembly Assembly of the saw attachment 325P5 Fitting the impact guard 325P5Dismantling Transport and storage Fuel safetyFuel Handling FuelPetrol, litre Two-stroke oil Litre FuellingTwo-stroke oil MixingCold engine Starting and StoppingCheck before starting Starting and stoppingStopping StartingGeneral working instructions Safety instructions regarding the surroundingsSafety instructions while working Working TechniquesBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Carburettor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburettor MufflerAir filter Cleaning the air filterCooling system Spark plugOiling the air filter Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataAttachments Art No Use with EC-declaration of conformityBar and chain combinations Applies to Europe only´z+HB,¶6R¨ Page 1140341-26 ´z+HB,¶6R¨ ´z+HB,¶6R¨