Mfg. Since 6/10 | I N S T R U C T I O N S | Model SB1044 |
Operation
Only use high quality
Following the cutting fluid manufacturer’s guidelines, check and maintain the specific gravity of the cutting fluid to its required level. Change the fluid when it becomes overly dirty, rancid, or contaminated.
BIOLOGICAL & POISON
HAZARD!
Use the correct personal protection equipment when handling cutting fluid. Follow federal, state, and fluid manufacturer requirements for proper disposal.
Running the pump without adequate fluid in the tank may permanently damage it. This damage is not covered by warranty.
To use the cutting fluid system:
1.Make sure the cutting fluid is properly serviced and the tank is filled.
2.Put on the necessary personal protection equipment.
3.Position the cutting fluid nozzle for your operation.
4.Use the control panel coolant switch to turn the cutting fluid pump ON.
Coolant Switch
Figure 3. SB1029 control panel.
5.Adjust the flow of cutting fluid for the type of flooding required.
Note: Promptly clean any splashed cutting fluid from the floor to avoid a slipping hazard.