Instruction Sheet, Unpacking | Southbend SB1044 instruction

MODEL SB1044

CUTTING FLUID KIT

Instruction Sheet

PHONE: (360) 734-1540 • www.southbendlathe.com

BIOLOGICAL & POISON

HAZARD!

Use the correct personal protection equipment when handling cutting fluid. Follow federal, state, and fluid manufacturer requirements for proper disposal.

Introduction

This cutting fluid kit is for the Model SB1029 Surface Grinding Machine. The system is designed to pump water-soluble cutting fluid to minimize grinding wheel wear, load-up, glazing, and heat. Using cutting fluid helps maximize the quality of workpiece results, especially on materials that should not be ground dry.

Specifications

•	Motor	1⁄8 HP
•	Phase & Cycle	3-Phase & 50/60 Hz
•	Voltage	220V/440V
•	Current	0.3/0.15 Amps
•	Pump Type	Jet
•	Pump Flow	8.2 GPM
•	Cutting Fluid Type	Water-Soluble Only
•	Maximum Tank Capacity	....................... 9 Gal.
•	Net Weight	73 lbs
•	Country of Origin	Taiwan

If you need help with your new model SB1044 Cutting Fluid Kit, contact us at: PHONE: (360) 734-1540

FAX: (360) 676-1075

EMAIL: sales@southbendlathe.com

Figure 1. Model SB1044.

Unpacking

This item was carefully packaged to prevent damage during transport. If you discover any damage, please immediately call Customer Service at (360) 734-1540 for advice. You may need to file a freight claim, so save the containers and all packing materials for possible inspection by the carrier or its agent.

Inventory
Item:		Qty
•	Tank Assembly w/Pump	1
	—Drain Hose 1⁜3⁄4" x 5'	1
	—Hose Clamp 1⁜3⁄4"	1
	—Delivery Hose 1⁄2'' x 9'	1
	—Hose Clamp 1⁜3⁄4''	1
	—Flex Conduit Power Cord 9'	1
	—Drain Adapter	1
	—Swivel Caster Wheels	4
•	Splash Guard	1
	—Button Head Cap Screw M6-1 x 10	4
	—Front & Rear Splash Panel	1 Ea
•	Coolant Trough	1

WARNING: No portion of this manual may be reproduced without written approval.

#CR13482 Printed in Taiwan

Southbend SB1044 instruction sheet Instruction Sheet, Introduction, Specifications, Unpacking