Electrical connections
Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be observed.
This cooker is designed to be connected to a 230 V 50 Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the hob rating plate. The rating plate is located on the bottom of the hob. A copy is attached on the back cover of this book.
The cooker is supplied with a 3 core flexible supply cord.
The cooker should be connected to a double pole switch with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations. The switch should be sited within 2m of the hob and be easily accessible upon completion of the installation.
The switch must not break the yellow and green earth cable at any point.
NOTE:
The earth wire should be about 2 cm longer than the live and neutral wires.
Ensure that the hob supply cord does not come into contact with surfaces with temperatures higher than 50 deg. C.
Supply Cable Specifications
For Uk use only |
|
|
| ||
|
|
|
|
|
|
Connection | Min. size | Cable / flex | Fuse | ||
via | Cable/flex | type |
|
| |
• Cooker | 6 mm2 | H05 |
| 30A | |
Control |
|
|
|
|
|
Circuit |
|
|
|
|
|
For Europe use only |
|
|
| ||
|
|
| |||
Min. size Cable/flex | Cable / flex type | Fuse | |||
3x 2.5 mm2 |
| H05 | 30 A | ||
|
|
|
| ||
|
|
|
|
|
|
33