Harbor Freight Tools 90692 See Figure B, To Install The U-Bracket Assembly, See Figure C

3.Install one Lower Vertical Support Bar (46) onto the Tool Rest Base of the lathe, and secure it by tightening the Support Bar Handle of the lathe. (See Figure A.)

4.Loosen the Tailstock Handle of the lathe, and remove the Tailstock from the Bed

of the lathe. (See Figure B.)

LOWER VERTICAL
SUPPORT BAR
(46)					TAILSTOCK
							TAILSTOCK
							HANDLE
TOOL REST BASE						BED OF LATHE
(44)
				TOOL REST HANDLE
SUPPORT BAR			(55)
		SUPPORT BAR INSERT (53)
HANDLE
							FIGURE B
(45)	HEX NUT (17)

5.Loosen the Hex Nut (17) from the bottom of the Tool Rest Base (44) and Support Bar Insert (53), and slide the Tool Rest Base assembly onto the Bed of the lathe. Then, re-tighten the Hex Nut. (See Figure B.)

6.Replace the Tailstock of the lathe onto the Bed of the lathe, and secure it by tightening the Tailstock Handle of the lathe. (See Figure B.)

To Install The U-Bracket Assembly:

1.Screw one Pattern Bolt (42) into the side of one Pattern Support Bar (41) and secure the Pattern Bolt with a Hex Nut (39). Then, slide the Pattern Support Bar into one U-Bracket (38). (See Figure C, next page.)

2.Screw one Handle (3) into the U-Bracket (38). (See Figure C.)

3.Insert the U-Bracket (38) onto the Lower Vertical Support Bar (46), and secure the U-Bracket by tightening the Handle (3). (See Figure C.)

4.Repeat Steps #1, #2, #3 for the remaining U-Bracket Assembly.

(See Figure C.)

SKU 90692 PAGE 6