Harbor Freight Tools 90692 To Attach The Support Bar, See Assy. Diagram, See Figure D, next

Page 7

PATTERN SUPPORT BAR (41)

U-BRACKET (38)

 

 

 

HANDLE (3)

 

 

 

 

 

 

LOWER VERTICAL

 

 

 

 

 

 

SUPPORT BAR

PATTERN BOLT (42)

(46)

 

 

 

U-BRACKET

 

 

 

 

ASSEMBLY

 

 

 

 

 

 

LOWER VERTICAL

SUPPORT BAR

(46)U-BRACKET ASSEMBLY

FIGURE C

To Attach The Support Bar:

1.Remove the End Cap (12) from each end of the Support Bar (54).

(See Assy. Diagram.)

2.Remove the two Square Nuts (47) from the Handles (48), and insert the Square Nuts into the T-Slot of the Support Bar (54).

(See Figure D, next page.)

3.Insert the threaded, bolt portion of the Handles (48) through the Lockwashers (34), Flat Washers (40), and holes in the Lower Vertical Support Bars (46). Then, screw the threaded, bolt portion of the Handles into the two Square Nuts (47) on the Support Bar (54).

(See Figure D.)

4.Replace the End Cap (12) on each end of the Support Bar (54).

(See Assy. Diagram.)

SKU 90692

PAGE 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents For technical questions, please call Lathe Duplicator AttachmentUnpacking Product SpecificationsGeneral Safety Warnings and Precautions Save this ManualIndustrial applications must follow Osha requirements Replacement parts and accessories When servicing, use onlySpecific Product Warnings and Precautions To Attach The Tool Rest Base Assembly InstructionsSee Figure B To Install The U-Bracket AssemblySee Figure C See Figure D See Assy. DiagramTo Attach The Support Bar See Figure D, nextTo Assemble The Tool Holder Figure DSee Figure G, next To Attach The Tool Holder AssemblyTo Attach The Safety Shield See Figure FOperating Instructions To Adjust The Cutting ToolSee Figure a INSPECTION, MAINTENANCE, and CleaningTo Perform Duplicate Turning Do not use damaged equipment Troubleshooting GuidePlease Read the Following Carefully Parts ListAssembly Diagram
Top Page Image Contents